GE Medical Systems MAC 1200 Operator's Manual page 22

1-10
The Basics: Safety Information
:$51,1*6
SHOCK HAZARD — Strictly observe the following
warnings. Failure to do so may endanger the lives of the
patient, the user and bystanders.
‹
Before using the device, the operator must ascertain
that it is in correct working order and operating
condition. In particular, all connectors, electrodes as
well as sensors and probes must be checked for signs
of damage. Damaged parts must be replaced
immediately, before use.
‹
When disconnecting the device from the power line,
remove the plug from the wall outlet first, before
disconnecting the cable from the device. Otherwise
there is a risk of coming in contact with line voltage
by inadvertently introducing metal parts in the
sockets of the power cord.
‹
The mains plug must be connected to an appropriate
power supply with a non-fused grounded-to-earth
wire. If these requirements cannot be met, operate
the device on battery power.
‹
Do not use multiple portable socket outlets (MPSO)
to connect the device to the power line.
‹
Devices may be connected to other devices or to parts
of systems only when it has been made certain that
there is no danger to the patient, the operators, or the
environment as a result. In those instances where
there is any element of doubt concerning the safety of
connected devices, the user must contact the
manufacturers concerned or other informed experts
as to whether there is any possible danger to the
patient, the operator, or the environment as a result
of the proposed combination of devices. Standards
IEC 60601-1-1/EN60601-1-1 must be complied with
in all cases.
‹
All devices of a system must be connected to the same
electric circuit. Devices which are not connected to
the same circuit must be electrically isolated (isolated
RS232 interface).
MAC 1200
2012250-022
Revision B