Cisco ME 3400 Command Reference Manual page 736

udld
•
•
Examples
This example shows how to enable UDLD on all fiber-optic interfaces:
Switch(config)# udld enable
You can verify your setting by entering the show udld privileged EXEC command.
Related Commands Command
show udld
udld port
udld reset
Cisco ME 3400 Ethernet Access Switch Command Reference
2-708
The no udld port interface configuration command followed by the udld port or udld port
aggressive interface configuration command to re-enable UDLD on the specified interface
The errdisable recovery cause udld and errdisable recovery interval interval global
configuration commands to automatically recover from the UDLD error-disabled state
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
Description
Displays UDLD administrative and operational status for all ports
or the specified port.
Enables UDLD on an individual interface or prevents a fiber-optic
interface from being enabled by the udld global configuration
command.
Resets all interfaces shut down by UDLD and permits traffic to
again pass through.
OL-9640-10