Spanning-Tree Mst Configuration - Cisco ME 3400 Command Reference Manual

spanning-tree mst configuration

spanning-tree mst configuration
Use the spanning-tree mst configuration global configuration command to enter multiple
spanning-tree (MST) configuration mode through which you configure the MST region. Use the no form
of this command to return to the default settings.
Syntax Description
This command has no arguments or keywords.
Defaults
The default mapping is that all VLANs are mapped to the common and internal spanning-tree (CIST)
instance (instance 0).
The default name is an empty string.
The revision number is 0.
Command Modes Global configuration
Command History Release
12.2(25)EX
12.2(25)SEG
Usage Guidelines On the Cisco ME switch, spanning-tree MST configuration is supported only on network node interfaces
(NNIs) or on enhanced network interfaces (ENIs) on which STP has been enabled. To set a port as an
NNI or ENI, enter the port-type {eni | nni} interface configuration command. To enable STP on an ENI,
enter the spanning-tree interface configuration command.
User network interfaces (UNIs) do not participate in Spanning Tree Protocol (STP).
The spanning-tree mst configuration command enables the MST configuration mode. These
configuration commands are available:
•
•
•
•
•
•
Cisco ME 3400 Ethernet Access Switch Command Reference
2-630
spanning-tree mst configuration
no spanning-tree mst configuration
Modification
This command was introduced.
The instance-id range changed to 0 to 4094.
abort: exits the MST region configuration mode without applying configuration changes.
exit: exits the MST region configuration mode and applies all configuration changes.
instance instance-id vlan vlan-range: maps VLANs to an MST instance. The range for the
instance-id is 0 to 4094. The range for vlan-range is 1 to 4094. You can specify a single VLAN
identified by VLAN ID number, a range of VLANs separated by a hyphen, or a series of VLANs
separated by a comma.
name name: sets the configuration name. The name string has a maximum length of 32 characters
and is case sensitive.
no: negates the instance, name, and revision commands or sets them to their defaults.
private-vlan: Though visible in the command-line help strings, this command is not supported.
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-10