Debug Platform Phy - Cisco ME 3400 Command Reference Manual

debug platform phy

debug platform phy
Use the debug platform phy privileged EXEC command to enable debugging of PHY driver
information. Use the no form of this command to disable debugging.
Syntax Description automdix
cablediag
dual-purpose
flcd {configure | ipc |
iter | trace}
flowcontrol
forced
init-seq
link-status
read
sfp
show-controller
speed
write
Although visible in the command-line help, the xenpak keyword is not supported.
Note
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(25)EX
Cisco ME 3400 Ethernet Access Switch Command Reference
B-58
debug platform phy {automdix | cablediag | dual-purpose | flcd {configure | ipc | iter | trace}
flowcontrol | forced | init-seq | link-status | read | sfp | show-controller | speed | write}
no debug platform phy {automdix | cablediag | dual-purpose | flcd {configure | ipc | iter | trace}
|
flowcontrol | forced | init-seq | link-status | read | sfp | show-controller | speed | write}
Display PHY automatic medium-dependent interface crossover
(Auto-MDIX) debug messages.
Display PHY cable-diagnostic debug messages.
Display dual-purpose PHY events.
Display PHY FLCD debug messages. The keywords have these meanings:
configure—Display PHY configure debug messages.
•
ipc—Display Interprocess Communication Protocol (IPC) debug
•
messages.
• iter—Display iter debug messages.
trace—Display trace debug messages.
•
Display PHY flowcontrol debug messages.
Display PHY forced-mode debug messages.
Display PHY initialization-sequence debug messages.
Display PHY link-status debug messages.
Display PHY-read debug messages.
Display PHY small form-factor pluggable (SFP) modules debug messages.
Display PHY show-controller debug messages.
Display PHY speed-change debug messages.
Display PHY-write debug messages.
Modification
This command was introduced.
Appendix B Cisco ME 3400 Ethernet Access Switch Debug Commands
|
OL-9640-10