Show System Mtu - Cisco ME 3400 Command Reference Manual

show system mtu

show system mtu
Use the show system mtu privileged EXEC command to display the global maximum transmission unit
(MTU) or maximum packet size set for the switch.
Syntax Description | begin
| exclude
| include
expression
Command Modes Privileged EXEC
Command History Release
12.2(25)EX
Usage Guidelines If you have used the system mtu or system mtu jumbo global configuration command to change the
MTU setting, the new setting does not take effect until you reset the switch.
The system MTU refers to ports operating at 10/100 Mb/s; the system jumbo MTU refers to Gigabit
ports; the routing MTU is the MTU for routed packets.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show system mtu command:
Switch# show system mtu
System MTU size is 1500 bytes
System Jumbo MTU size is 5000 bytes
System Alternate MTU size is 2000 bytes
Routing MTU size is 1500 bytes
This is an example of output when you have defined an alternate MTU size, but not reloaded the switch:
Switch# show system mtu
System MTU size is 1500 bytes
System Jumbo MTU size is 5000 bytes
System Alternate MTU size is 1500 bytes
On next reload, System Alternate MTU will be 2000 bytes
Routing MTU size is 1500 bytes
Cisco ME 3400 Ethernet Access Switch Command Reference
2-576
show system mtu [ | {begin | exclude | include} expression]
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-10