Cisco ME 3400 Command Reference Manual page 320

mvr (global configuration)
Examples This example shows how to enable MVR:
Switch(config)# mvr
Use the show mvr privileged EXEC command to display the current setting for maximum multicast
groups.
This example shows how to configure 228.1.23.4 as an IP multicast address:
Switch(config)# mvr group 228.1.23.4
This example shows how to configure ten contiguous IP multicast groups with multicast addresses from
228.1.23.1 to 228.1.23.10:
Switch(config)# mvr group 228.1.23.1 10
Use the show mvr members privileged EXEC command to display the configured IP multicast group
addresses.
This example shows how to set the maximum query response time as one second (10 tenths):
Switch(config)# mvr querytime 10
This example shows how to set VLAN 2 as the multicast VLAN:
Switch(config)# mvr vlan 2
You can verify your settings by entering the show mvr privileged EXEC command.
Related Commands Command
mvr (interface configuration)
show mvr
show mvr interface
show mvr members
Cisco ME 3400 Ethernet Access Switch Command Reference
2-292
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
Description
Configures MVR ports.
Displays MVR global parameters or port parameters.
Displays the configured MVR interfaces with their type, mode,
VLAN, status and Immediate Leave configuration, and can also
displays all MVR groups of which the interface is a member.
Displays all ports that are members of an MVR multicast group;
if the group has no members, its status is shown as Inactive.
OL-9640-10