Cisco ME 3400 Command Reference Manual page 481

Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
Examples This is sample output from the show interface rep command:
Switch # show interface rep
Interface
---------------------- ------ ------------ ----------- ----
GigabitEthernet 0/1
GigabitEthernet 0/2
FastEthernet 0/4
This is sample output from the show interface rep command when the edge port is configured to have
no REP neighbor. Note the asterisk (*) next to Primary Edge.
Switch# show interface rep
Interface
---------------------- ------ --------------
GigabitEthernet0/1
GigabitEthernet0/2
This is sample output from the show interface rep command when external neighbors are not
configured:
Switch # show interface rep
Interface
---------------------- ------ ------------ ----------- ----
GigabitEthernet0/1
GigabitEthernet0/2
This is sample output from the show interface rep detail command for a specified interface:
Switch # show interface gigabitethernet0/2 rep detail
GigabitEthernet0/2
Segment-id: 1 (Segment)
PortID: 00030019E85BDD00
Preferred flag: No
Operational Link Status: INIT_DOWN
Current Key: 00000000000000000000
Port Role: Fail
Blocked VLAN: 1-4094
Admin-vlan: 1
Preempt Delay Timer: disabled
LSL Ageout Timer: 5000 ms
Configured Load-balancing Block Port: 1234567890123456
Configured Load-balancing Block VLAN: 1-4094
STCN Propagate to: none
LSL PDU rx: 0, tx: 0
HFL PDU rx: 0, tx: 0
BPA TLV rx: 0, tx: 0
BPA (STCN, LSL) TLV rx: 0, tx: 0
BPA (STCN, HFL) TLV rx: 0, tx: 0
EPA-ELECTION TLV rx: 0, tx: 0
EPA-COMMAND TLV rx: 0, tx: 0
EPA-INFO TLV rx: 0, tx: 0
Related Commands Command
rep segment
show rep topology
[detail]
OL-9640-10
Seg-id Type
1 Primary Edge
1 Edge
2
Seg-id Type
2
2 Primary Edge*
Seg-id Type
1
2
REP enabled
Description
Enables REP on an interface and assigns a segment ID. This command is also
used to configure a port as an edge port, a primary edge port, or a preferred
port.
Displays information about all ports in the segment, including which one was
configured and selected as the primary edge port.
Cisco ME 3400 Ethernet Access Switch Command Reference
LinkOp Role
TWO_WAY Open
TWO_WAY Open
INIT_DOWN Fail
LinkOp Role
----------- ----
TWO_WAY Open
TWO_WAY Open
LinkOp Role
NO_NEIGHBOR FailNoNbr
NO_NEIGHBOR FailLogOpen
show interfaces rep
2-453