Cpu Traffic Qos Precedence - Cisco ME 3400 Command Reference Manual

cpu traffic qos precedence

cpu traffic qos precedence
Use the cpu traffic qos precedence command in global configuration mode to configure quality of
service (QoS) marking for control plane traffic. To return to the default value, use the no form of this
command.
Syntax Description precedence-value
cos
table-map
table-map-name
dscp
table-map
table-map-name
precedence
table-map
table-map-name
Command Default Control plane (CPU) traffic is not marked for QoS.
Command Modes Global configuration
Cisco ME 3400 Ethernet Access Switch Command Reference
2-68
cpu traffic qos precedence {precedence_value | cos [table-map table-map-name] | dscp
[table-map table-map-name] | precedence [table-map table-map-name]}
no cpu traffic qos precedence {precedence_value | cos [table-map table-map-name] | dscp
[table-map table-map-name] | precedence [table-map table-map-name]}
Configure the precedence value. The range is from 0 to 7. If no
IP-precedence value is configured, the protocol-specific default value for
each packet is applied.
Note
Configure the CoS value based on the CoS value in the packet, using a
table-map.
Specify the table-map to use for marking the CPU traffic CoS based on the
CoS value in the packet.
Configure the differentiated services code point (DSCP) value based on the
IP-DSCP value in the packet, using a table-map.
Specify the table-map to use for marking the CPU traffic precedence based
on the DSCP value in the packet.
Configure the IP-precedence value based on the IP-precedence value in the
packet, using a table-map.
Specify the table-map to use for marking the CPU traffic precedence based
on the precedence value in the packet
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
You can substitute the following keywords for the numbers 0 to 7:
routine (0)
•
priority (1)
•
immediate (2)
•
flash (3)
•
flash-override (4)
•
• critical (5)
• internet (6)
• network (7)
OL-9640-10