Cisco ME 3400 Command Reference Manual page 342

Ethernet access switch

Hide thumbs Also See for ME 3400:

Table of Contents

permit (MAC access-list configuration)

After an access control entry (ACE) is added to an access control list, an implied deny-any-any

condition exists at the end of the list. That is, if there are no matches, the packets are denied. However,

before the first ACE is added, the list permits all packets.

For more information about MAC-named extended access lists, see the software configuration guide for

this release.

This example shows how to define the MAC-named extended access list to allow NETBIOS traffic from

any source to MAC address 00c0.00a0.03fa. Traffic matching this list is allowed.

Switch(config-ext-macl)# permit any host 00c0.00a0.03fa netbios

This example shows how to remove the permit condition from the MAC-named extended access list:

Switch(config-ext-macl)# no permit any 00c0.00a0.03fa 0000.0000.0000 netbios

This example permits all packets with Ethertype 0x4321:

Switch(config-ext-macl)# permit any any 0x4321 0

You can verify your settings by entering the show access-lists privileged EXEC command.

Related Commands

deny (MAC access-list

configuration)

mac access-list extended

show access-lists

Cisco ME 3400 Ethernet Access Switch Command Reference

Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands

Denies non-IP traffic to be forwarded if conditions are matched.

Creates an access list based on MAC addresses for non-IP traffic.

Displays access control lists configured on a switch.