Measurement Example; Required Equipment; Preparing For A Measurement - Keysight E4990A Help Manual

E4990A Help

Measurement Example

Measurement Example
This chapter guides you through a tour of the basic measurement functions
of the E4990A Impedance Analyzer. If you are new to the E4990A, this
tutorial should help you get familiar with the instrument.

Required Equipment

•

Preparing for a Measurement

•
Specifying Measurement Conditions
•
Fixture Compensation
•
Carrying Out Measurement and Viewing Results
•
Results of Analysis
•
Softkey Shortcuts
•
Required Equipment
To perform all of the steps in this example, you must have the following
equipment:
E4990A Impedance Analyzer (1 unit)
•
16047E Text Fixture for Lead Components (1 piece)
•
DUT: Capacitor with lead wires having self-resonance frequency of
•
100 MHz or lower, such as a 0.1 μF ceramic capacitor (1 piece)
Other topics about Measurement Example
Preparing for a Measurement
Connect the 16047E Test Fixture
•
Turn ON the Power
•
Other topics about Measurement Example
Prepare the E4990A for measurement by taking the following steps. This
procedure assumes that the E4990A has been correctly installed and set
up.
Connect the 16047E Test Fixture
Connect the E4990A to the 16047E Test Fixture for Lead Components.
1. Attach the 16047E test fixture to the test connectors on the front
panel of the E4990A by gradually coupling the four BNC connectors
and fastening screws of the fixture with the test connectors and
accessory mounting holes of the instrument until they are in
complete contact.
42