Calibration For Four-Terminal Pair, 1-M Extension - Keysight E4990A Help Manual

E4990A Help
Direct connection type test fixtures include:
16034E Chip component test fixture
•
16034G Chip component test fixture
•
16034H Chip component test fixture
•
16044A Chip component test fixture
•
16047A Lead component test fixture
•
16047D Lead component test fixture
•
16047E Lead component test fixture
•
Although the following test fixtures have cables, their calibration must be
performed in the same way as a direct connection type test fixture:
16065A External DC Bias Fixture
•
16089A Kelvin Clip Lead
•
16089B Kelvin Clip Lead
•
16089C Kelvin Clip Lead
•
16089D Alligator Clip Lead
•
16089E Kelvin Clip Lead
•
Perform the fixture compensation in accordance with
Compensation.
user calibration nor port extension compensation is required for
measurement (they cannot be performed).
Other topics about Calibration
B. Calibration for Four-Terminal Pair, 1-m Extension
This section describes the calibration procedures to follow when the four-
terminal pair port of the E4990A is extended with a 1-meter-long four-
terminal pair configuration and the device is connected to the cable's end
with a minimal connection.
104
When you use a direct connection type test fixture, neither
Fixture