Selecting The Graph Axis Format - Keysight E4990A Help Manual

E4990A Help
You can set each measurement parameter without specifying the
active trace or checking its current state.
Selecting Parameter Independently
You can select the measurement parameter for each trace independently.
1. Press
Meas
trace 3 or 4, increase the
2. Select the desired measurement parameter for the trace.
either DC Bias or Log DC Bias.

Selecting the Graph Axis Format

When Using Cartesian Coordinates
•
When Using Complex Parameters (COMPLEX Z-Y)
•
Other topics about Setting Up the Display of Measurement Results
When Using Cartesian Coordinates
Unless the E4990A is configured to perform a COMPLEX Z-Y measurement
(complex impedance for Trace 1, complex admittance for Trace 2), it
displays measurement results in a Cartesian-coordinate graph whose
horizontal and vertical axes indicate the sweep and measurement
parameter values, respectively. Use the following procedure to select the
vertical axis format for a Cartesian-coordinate graph:
1. Activate the trace for which you want to set the axis format.
2. Press the
3. Select the desired vertical axis format by pressing the appropriate
key, Linear|Log.
based on the selected sweep type.
When Using Complex Parameters (COMPLEX Z-Y)
When the Agilent E4990A is configured to perform a COMPLEX Z-Y
measurement (complex impedance for Trace A, complex admittance for
Trace B), use the following procedure to select the graph axis formats:
1. Activate the trace for which you want to set the axis format.
2. Press
Format
3. Select the desired graph axis format by pressing the appropriate key,
Complex|Polar.
126
> Trace 1, Trace 2, Trace 3 or Trace 4. When you set the
number of
Vdc and Idc can be selected when the
Format key to display the Format menu.
The horizontal axis format is automatically determined
> Complex Format.
trace.
sweep type is set at