imagistics ipc1-im8130 Operator's Manual page 104

and
to select hole punching.
Fragment of the Setup Page Showing the Finishing Icon
Finishing icon: shows the selected stapling and hole punch
positions. You cannot click this icon. It shows a representation of the
current selection for the staple position, hole punch position, or both.
If the staple or hole punch option is not installed, the drop-down list
is disabled.
Staple has higher priority than hole punch. Selecting a staple position
determines the available hole punch positions. The positions are:
Stapling Option
None
Upper left
Top (double)
Upper right
Left (double)
Print Profile: provides access to a predefined set of driver properties
that allow you to auto-configure print jobs.
Department Code: provides a field where you can enter the five-digit
department code. You can also press Alt+C.
Destination: selects the copier tray to which you want to output the
print job. You can also press Alt+D. The options are:
Note: This list may change or be disabled depending on other options.
Restore Defaults: restores the factory preset Setup properties. You
can also press Alt+U.
88
. You can also press Alt+T to select stapling and Alt+H
Hole Punch
Stapling and Hole Punching Positions
Available Hole Punch Positions
None, top, left
None, top, left
None, top
None, top
None, left
Open: opens an existing print profile. You can also press Alt+P.
Save: saves the current setup settings in a print profile. You can
also press Alt+V.
Finishing icon
ipc1-im8130 Operator's Guide
and .
Tray 1 Tray 2