Reviewing Batch Data - Model T - Elcometer 500 User Manual

14 BATCHING - MODEL T (continued)
Batch/Open Existing Batch; Open an existing batch.

Batch/Review Batch; Review the readings, statistics, batch

information, calibration and limit information and a graph of all
readings - see Section 15 'Reviewing Batch Data - Model T'.
Batch/Copy Batch; Copy a batch including the batch header

information, calibration and limit information.
Batch/Edit Batch/Rename Batch; Rename an existing batch.

Batch/Edit Batch/Clear Batch; Clear all readings within a

batch - but leaving all batch header information.
Batch/Edit Batch/Delete Batch; Delete a single batch or all

batches entirely from the gauge.
Batch/Deleted Reading/Delete Without Tag; Delete the last

reading entirely.
Batch/Deleted Reading/Delete With Tag; Delete the last

reading but mark it as deleted in the batch memory.

15 REVIEWING BATCH DATA - MODEL T

15.1 BATCH STATISTICS (Batch/Review Batch/Statistics)
Displays statistical information for the batch including (Figure 26):
Number of readings in the batch (n:)

Average reading for the batch (

Lowest reading in the batch (Lo:)

Highest reading in the batch (Hi:)

Standard Deviation (σ:)

Coefficient of Variation (cv%:)

Low limit value (

number of readings below the
low limit (
High limit value (

above the high limit (
e
Range ( ); the difference between

the highest and lowest reading
in the batch
NDFT (Nominal Dry Film Thickness) value (

e
For batches of more than one reading.
www.elcometer.com
e
e
) - if set - and the
)
) - if set - and the number of readings
)
e
:)
X
e
e
Figure 26
)
NDFT:
R
en-26