Pin Lock - Model T - Elcometer 500 User Manual

13 PIN LOCK - MODEL T

The 'PIN Lock' feature prevents the user from accidentally adjusting
the gauge settings.
To set a PIN code:
1 Press Menu/Setup/PIN Lock.
2 Set the four digit PIN code using the
softkeys to select 0 to 9 and the  softkey
to move to the next digit (Figure 25).
3 Press 'Ok' to set, 'Escape' to cancel or
'Adjust' to amend the PIN code.
When enabled, the following features are disabled and can not be
adjusted:
Menu/Calibration/Calibrate
Menu/Calibration/Cal Memory
Menu/Reset
Menu/Limit Memories/Create Limit Memory
Menu/Limit Memories/Edit Limit Memory
Batch/New Batch/Batch Limits/Create Limit Memory
To unlock the PIN code:
1 Press Menu/Setup/PIN Lock.
2 Enter the four digit PIN code using the
9 and the  softkey to move to the next digit .
3 Press 'Ok' or 'Escape' to cancel.
Note: Should the user forget or lose the PIN code, it can be disabled via ElcoMaster .
Using the USB cable supplied, simply connect the gauge to a PC with
®
ElcoMaster version 2.0.57 or higher installed and select Edit/Clear PIN.
14 BATCHING - MODEL T
The Elcometer 500 Model T can store 100,000 readings in up to 1,000
batches. The following batch functions are available:
Batch/New Batch; Creates a new batch.

Batch/New Batch/Fixed Batch Size; Pre-define the number of

readings which are stored in a batch. The gauge will notify the
user when a batch is complete and ask if another batch is to be
opened. These batches are then linked when transferred to
ElcoMaster .
d
The  softkey will appear when the first 'X' is changed to a number.
en-25
R
d
®


Menu/Calibration/Cal Method
Menu/Calibration/Factory Calibration
Batch/Edit Batch/Delete Batch
Batch/Deleted Reading

softkeys to select 0 to

d
www.elcometer.com
Figure 25
®