Modify Network Settings From The Oracle Ilom Cli - Oracle Sun Server X4-4 Installation Manual

Modify Network Settings From the Oracle ILOM
CLI
If you want to modify the network settings currently configured for the server from the Oracle
ILOM CLI, use the following procedure.
You can also change network settings using the BIOS Setup Utility. For instructions,
Note -
refer to "Access the BIOS Setup Utility" in Sun Server X4-4 Service
Log in to the Oracle ILOM CLI using the relevant method in
1.
ILOM Using a Local Serial Connection" on page 55
Using a Remote Ethernet Connection" on page
2. Perform the network configuration instructions that apply to your network
environment, then test the network settings:
To view or configure IPv4 network settings, perform Step 3 and Step 4.
■
To view or configure IPv6 network settings, perform Steps 5 through 8.
■
3.
For IPv4 network configurations, use the cd command to navigate to the /SP/
network directory:
->
cd /SP/network
4. Do one of the following:
If you have a DHCP server on the network, type the following command to
■
view the settings assigned to the server by the DHCP server:
->
show
■
If there is no DHCP server, or if you want to assign settings, use the set
command to assign values for the properties listed in the following table.
For example:
->
set pendingipdiscovery=static
->
set pendingipaddress=10.8.183.106
->
set pendingipnetmask=255.255.255.0
->
set pendingipgateway=10.8.183.254
->
set commitpending=true

Modify Network Settings From the Oracle ILOM CLI

Manual.
"Log In to Oracle
or "Log In to Oracle ILOM
56.
Connecting to Oracle ILOM 59