Server Supported Components - Oracle Sun Server X4-4 Installation Manual

Callout
3
4
5
6
7
8
9
10
11
12

Server Supported Components

This section describes the components that are supported in the Sun Server X4-4.
Component
Processor (CPU)
Memory
Storage devices
Description
PSU 1 indicator panel
PSU 1 AC inlet
System status indicator panel
PCIe card slots 1–6
Network (NET) 10 GbE ports: NET0–NET3
USB 2.0 ports (2)
PCIe card slots 7–11
Service processor (SP) network management (NET MGT) port
Serial management (SER MGT)/RJ-45 serial port
DB-15 video port
Sun Server X4-4
Intel Xeon® E7-8895 v2 15-core 2.8 GHz processor.
Supported configurations:
■ Two processors installed in sockets 0 and 1.
■ Four processors installed in sockets 0 through 3.
Up to eight memory riser cards are supported (two risers per CPU) in the server chassis. Each
memory riser supports up to twelve DDR3-1600 ECC low-voltage registered or load-reduced
DIMMs, allowing up to twenty-four DIMMs per processor. Installed DIMMs must be the
same type and size.
■ In a two CPU system, you can install up to a maximum of 1.5 TB of system memory.
■ In a four CPU system, you can install up to a maximum of 3 TB of system memory.
Refer to the Service Manual for DIMM population rules and supported configurations.
For internal storage, the server chassis provides:
■ Six 2.5-inch drive bays, accessible through the front panel. All bays can be populated
with SAS-2 HDDs or SATA-3 SSDs.
■ An optional DVD+/-RW drive on the front of the server, below the drive bays. This
SATA DVD drive connects to a USB-SATA bridge, so that the drive appears to the
system as a USB storage device.
■ SAS-2 HBA PCIe card options:
■ Sun Storage 6 Gb SAS PCIe HBA. Supports RAID levels : 0, 1, 10.
Server Supported Components
Server Features and Components 17