Oracle Sun Server X4-4 Installation Manual page 61

Commands:
cd
show
7.
To configure an IPv6 auto-configuration option, use the set command to specify
the following auto-configuration property values. For example:
->
set state=enabled
->
set autoconfig=dhcpv6_stateless
Property
state
autoconfig
The IPv6 configuration options take effect after they are set. You do not need to commit
Note -
these changes under the /network target.
You can enable the stateless auto-configuration option to run at the same time as when
Note -
the option for dhcpv6_stateless is enabled or as when the option for dhcpv6_stateful is
enabled. However, the auto-configuration options for dhcpv6_stateless and dhcpv6_stateful
should not be enabled to run at the same time.
To set a static IPv6 address, complete these steps:
8.
Value to Set Description
The IPv6 network state is enabled by default. To enable
enabled or disabled
an IPv6 auto-configuration option, this state must be set to
enabled.
Values include:
Specify this command, followed by the autoconfig value you
want to set.
stateless
■ stateless (default setting)
dhcpv6_stateless
dhcpv6_stateful
■ dhcpv6_stateless
disable
■ dhcpv6_stateful
■ disable
Modify Network Settings From the Oracle ILOM CLI
Automatically assigns IP address learned from IPv6
network router.
Automatically assigns DNS information learned from the
DHCPv6 server. The dhcpv6_stateless property value is
available in Oracle ILOM as of 3.0.14.
Automatically assigns the IPv6 address learned from the
DHCPv6 server. The dhcpv6_stateful property value is
available in Oracle ILOM as of 3.0.14.
Disables all auto-configuration property values and sets the
read-only property value for link local address.
Connecting to Oracle ILOM 61