Set Separate Time For A Step - SHOWTEC Creator 1024 pro Manual

Creator 1024 PRO
 LTP Wait: The wait time before an LTP channel fading
 LTP Fade: The fading time of an LTP channel
 Overlap (ON/OFF): If set to ON, then the overlap effect will be active as the fade time runs.
 Priority (Lowest/Low/Normal/High/Highest): Set the priority for your playbacks. Playbacks with
higher priority will always override the playbacks with lower priority.
 Quick Group: Press <E> to enter. Turn the Wheel V to set the number of quick groups. The
adjustment range is between 0-80. The fixtures in the step can be divided into groups. Fixtures
from the same group will act the same.
 Advanced Group: Sometimes it is useful to have several fixtures to run a shape as a group. In this
case, you can use the Group function. Press <A> [Advanced Group] to enter. The menu
contains the following options:
 Number of groups: The number of groups which we need to define. By setting Spread, you
can select the group quantity, not fixture quantity.
 Group number: The fixture buttons of the group number will light up. To add a fixture to the
group number, press the desired fixture button until it lights up. If you press any button by
mistake, you will need to return to the settings of the original fixture group.
 Group -> <-: Outward auto grouping
 Group <- ->: Inward auto grouping
 Reset: Reset the group number to fixture number.
 Auto group: The fixtures will automatically be grouped, in a consequent order.
 Increase group: The fixtures will be grouped with an add-on number.

14. Set Separate Time for a Step

Fade in/out time can be set to each single step separately. A chase step with separate time is called a
complex step; if it is using the global time, then it is a simple step. To set separate time for each step, you
can press <Unfold>.
01) Press <Unfold>, and then press the playback button of the chase.
02) Press <B> [Edit Time], and then press the playback button of the step.
03) On Page 2 of Time menu, the option B is "Link". If "Link" is set to ON, the chase will automatically run
step by step. If "Link" is set to OFF, then you need to press <Go+> or <Go-> to run the steps one after
another.
04) Press <Enter> twice to save and exit or press <Exit> to exit without saving.
 Any modification will turn a simple step into a complex step.
 To turn a complex step back to a simple step, press <Fixture menu> in the time editing menu to
change.
Ordercode: 50731
32