Table of Contents
Advertisement
Performer 2000 Fresnel DDT MKII
Installation
Remove all packing materials from the Performer 2000 Fresnel DDT MKII. Check if all foam and plastic
padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Color frame retaining clip
The color frame holder is equipped with a spring-loaded retaining clip. This prevents color frames and
accessories from falling out.
Make sure that all color frame accessories are locked in position with the retaining clip
before hanging the Performer 2000 Fresnel DDT MKII.
01) Release the retaining clip by pressing the lock towards the lens and pressing the longer side of the
screw. The retaining clip will open.
02) Insert the color frame(s).
03) Lock the retaining clip by pressing the retaining clip towards the lens.
Fig. 04
Ordercode: 33036
11
Advertisement
Table of Contents
