Table of Contents
Advertisement
Stardrape White LED WhiteCloth
Controller
Fig. 02
01) IEC power connector 100-240V IN + Fuse F2AL/250V
02) Power switch ON/OFF
03) 3-pin DMX signal connector IN
04) 3-pin DMX signal connector OUT
05) 5-pin curtain connector
06) Ground/earth connection
07) 4-digit LED display + menu buttons
08) Air intake grill
09) Safety eye
10) Inclination screw
Installation
Remove all packing materials from the Stardrape White LED WhiteCloth. Check if all foam and plastic
padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Ordercode: 40461W
10
Advertisement
Table of Contents
