The Include Function; The "Off" Button; Copy A Scene; Delete A Scene - SHOWTEC Creator 1024 pro Manual

Creator 1024 PRO

9. The Include Function

The Include function lets you load selected parts of a scene back into the programmer. (Normally, only
manual changes to fixtures are put in the programmer). You can then use this to make a new scene. This
is useful if you want to make a scene which is similar to one you already have.
01) Press <Copy/Include>.
02) Press the playback button of the desired scene.
03) Press <C> to select "Include selected fixtures only" or not.
04) Press <Enter> to include the data.

10. The "Off" Button

The <Off> button allows you to remove an attribute which has been stored in a scene, as if you never
recorded it.
For example, suppose that you recorded a scene which had scans at a certain position, with the color
set to green. If you later decide that you do not want the recorded color at all in the scene, so that the
previous color setting of the scans will be used, you can use the Off function to turn off the color in the
scene. You can also use the Off function to remove complete fixtures from a scene.
Pressing the <Off> button is not the same as recording an attribute at zero.
01) Turn on the scene which you want to edit, so you can see what you are doing.
02) Select the fixtures you want to change.
03) Press the <Off> button (one of the blue command buttons) to display the Off menu.
04) To switch off all attributes of the selected fixtures, press <A> (this will remove the fixtures from the
scene).
05) To switch off selected attributes, press the appropriate attribute button, then use <B> and <C> to set
each attribute to Off (the screen shows which attribute will be turned off for each button)
06) Repeat from 3 to turn off other attributes, or from 2 to turn off other fixtures.
07) Press <Memory/Cue>.
08) Press one of the playback buttons for the scene you are editing, to save the changes. Unchanged
information is not affected.
 Attributes which are Off are shown on the screen. (The stage output will not change as the output
values remain at their last settings).
Attributes or fixtures set to Off can be turned back on again by selecting them in the usual way and

changing them using the wheels.
 You can also use this function to turn off fixtures or attributes in a palette entry. Use the procedure
above, but instead of editing and recording a scene, edit and record a palette entry instead.

11. Copy a Scene

01) Press <Copy/Include>.
02) Press the playback button that stores a scene.
03) Press an empty playback button to copy.

12. Delete a Scene

01) Press <Delete>.
02) Press the desired playback button.
03) Press the playback button again, to delete.
Ordercode: 50731
26