Table of Contents
Advertisement
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Remove all packing materials from the Cyclone 4. Check that all foam and plastic padding is removed.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Control Modes
There are 4 modes:
One Cyclone
(Auto Run
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Plug the end of the electric mains power cord into a proper electric power supply socket.
3. When the Cyclone is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 12 for more information about the Auto Run Programs.
One Cyclone (Sound-control)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Plug the end of the electric mains power cord into a proper electric power supply socket.
3. Turn on the music. If device is set to
will react to the beat of the music.
options.
Multiple Cyclones
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Plug the end of the electric mains power cord into a proper electric power supply socket.
3.
Use a 3-p XLR cable to connect the Cyclone.
The pins:
4.
Link the units as shown in (Fig. 2), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
use the same functions on the master device as described on page 12 (Auto Run or
This means on the master device you can set your desired operation Mode and all slave devices will
react the same as the master device.
• Auto Run Programs
• Sound-controlled
• Master/Slave
• DMX512
Programs)
Please see page 12 for more information about the Sound-control
(Master/Slave
control)
1.
Earth
2.
Signal -
3.
Signal +
Multiple Cyclones (Master/Slave control)
(Audio) and you have pressed enter, then the fixture
7
You can
Music control).
Fig. 2
Advertisement
Table of Contents
