Table of Contents
Advertisement
Performer Profile Mini MKII 5600K
Back
Fig. 02
07) Manual dimmer control
08) Schuko power cable (1,4 m)
09) 3-pin DMX signal connector IN
10) 3-pin DMX signal connector OUT
Installation
Remove all packing materials from the Performer Profile Mini MKII 5600K. Check if all foam and plastic
padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 110V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Ordercode: 33091
8
Advertisement
Table of Contents
