Replacement Procedures - GE AKTA avant User Manual

7.8

Replacement procedures

About this section
This section gives instructions for the replacement procedures to be performed by the
user of ÄKTA avant.
In this section
This section contains the following subsections:
Section
7.8.1 Replace tubing and connectors
7.8.2 Replace the Mixer
7.8.3 Replace the O-ring inside the Mixer
7.8.4 Replace the UV monitor U9-M flow cell
7.8.5 Replace UV monitor U9-L flow cell
7.8.6 Replace Flow restrictor
7.8.7 Replace the inlet filters
7.8.8 Replace pump head check valves
7.8.9 Replace pump rinsing system tubing
7.8.10 Replace a valve module
7.8.11 Replace pump pistons, piston seals, O-rings and rinse mem-
branes
ÄKTA avant User Manual 29035184 AE
WARNING
Disconnect power. Always disconnect power from the instrument
before replacing any component on the instrument, unless stated
otherwise in the user documentation.
7 Maintenance

7.8 Replacement procedures

See page
336
338
340
342
345
347
348
349
352
354
357
335