Replacement Procedures - GE AKTApure User Manual

7 Maintenance

7.8 Replacement procedures

7.8 Replacement procedures

Introduction
This section gives instructions for the replacement procedures to be performed by the user of ÄKTA
pure.
In this section
This section contains the following subsections:
Section
7.8.1 Replace tubing and connectors
7.8.2 Replace internal tubing in Fraction collector F9-C
7.8.3 Replace the Mixer
7.8.4 Replace the O-ring inside the Mixer
7.8.5 Replace the UV monitor U9-M flow cell
7.8.6 Replace the UV monitor U9-L flow cell
7.8.7 Replace Flow restrictor
7.8.8 Replace the inlet filters
7.8.9 Replace the pump head check valves
7.8.10 Replace pump piston seals of Pump P9 or P9H
7.8.11 Replace pump piston seals of Pump P9-S
7.8.12 Replace pump pistons
7.8.13 Replace pump rinsing system tubing
316
WARNING
Disconnect power. Always disconnect power from the instrument before replacing
any component on the instrument, unless stated otherwise in the user documenta-
tion.
See page
317
319
322
323
325
328
330
331
332
335
344
351
352
ÄKTA pure User Manual 29119969 AB