Check And Change The Node Id Of A Module - GE AKTA avant User Manual

9.15 Check and change the Node ID of a module

Introduction
Node ID is a unit number designation that is used by the instrument to distinguish be-
tween several units of the same type. All standard valves and available optional modules
are pre-configured to the default function. However, the function of a valve or module
can be changed by changing the Node ID. Also, in a troubleshooting situation it may be
useful to check a valve's or module's Node ID.
Note:
Node ID for standard modules
The following table lists the Node ID for the standard modules.
Module
System Pump A
System Pump B
Sample Pump
Pressure Monitor, system pressure
Pressure Monitor, sample pressure
Mixer
Injection Valve
Quaternary Valve
Inlet Valve A
Inlet Valve B
Sample Inlet Valve
Column Valve
Precolumn pressure monitor in Column
Valve
Post-column pressure monitor in Column
Valve
ÄKTA avant User Manual 29035184 AE
The function of a valve or module is defined by its Node ID, not by its physical
position.
9 Reference information
9.15 Check and change the Node ID of a module
Label
P9 A or P9H A
P9 B or P9H B
P9-S or P9H S
R9
R9
M9
V9-Inj or V9H-Inj
Q9
V9-IA or V9H-IA
V9-IB or V9H-IB
V9-IS or V9H-IS
V9-C or V9H-C
N/A
N/A
Node ID
0
1
2
0
1
0
4
0
0
1
2
5
2
3
515