Grandstream Networks UCM6108 User Manual page 79

http://arttel.ru
Default Destination
Time Condition
Start Time
End Time
Date
Week
Destination
Firmware Version 1.0.2.21
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102
use this rule.
International: The highest level required. Only users with
x
international level can use this rule.
This setting is used to compared with the outbound trunk's permission
level when the inbound call dials out via a trunk on the UCM6100.
Therefore, it's usually used only when the "Default Destination" is set to
"By DID".
Select the default destination for the inbound call.
By DID
x
When "By DID" is used, the UCM6100 will look for the destination
based on the number dialed, which could be local extensions,
conference, call queue, ring group, paging/intercom group, IVR,
voicemail groups and Fax extension as configured in "DID
destination" under "DID Features" dialog. If the dialed number
matches the DID pattern, the call will be allowed to go through.
Extension
x
Voicemail
x
Conference Room
x
Queue
x
Ringgroup
x
Page
x
Vmgroup
x
Fax
x
DISA
x
IVR
x
Select the start time "hour:minute" for the trunk to use the inbound rule.
Select the end time "hour:minute" for the trunk to use the inbound rule.
Select "By Week" or "By Day" and specify the date for the trunk to use
the inbound rule.
Select the day in the week to use the inbound rule.
Select the default destination for the inbound call.
By DID
x
When "By DID" is used, the UCM6100 will look for the destination
based on the number dialed, which could be local extensions,
conference, call queue, ring group, paging/intercom group, IVR,
voicemail groups and Fax extension as configured in "DID
destination" under "DID Features" dialog. If the dialed number
UCM6100 Series IP PBX User Manual Page 78 of 159