Grandstream Networks UCM6108 User Manual page 136

http://arttel.ru
Max Registration/Subscription
Time
Min Registration/Subscription
Time
Music On Hold Interpret
Music On Hold Suggest
Enable Relaxed DTMF
DTMF Mode
RTP Timeout
RTP Hold Timeout
Trust Remote Party ID
Send Remote Party ID
Generate In-Band Ringing
Firmware Version 1.0.2.21
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102
Configure the maximum duration (in seconds) of incoming registration
and subscription allowed by the UCM6100. The default setting is 3600.
Configure the minimum duration (in seconds) of incoming registration
and subscription allowed by the UCM6100. The default setting is 60.
Configure the Music On Hold class for the channel when being put on
hold. This is used when the Music On Hold class is not set on the
channel and the peer channel placing the call on hold doesn't have
"Music On Hold Suggest".
Configure the Music On Hold class to suggest to the peer channel when
placing the peer on hold.
Select to enable relaxed DTMF handling. The default setting is "No".
Select DTMF mode to send DTMF. The default setting is RFC2833. If
"Info" is selected, SIP INFO message will be used. If "Inband" is
selected, 64-kbit codec PCMU and PCMA are required. When "Auto" is
selected, "RFC2833" will be used if offered, otherwise "Inband" will be
used. The default setting is "RFC2833".
During an active call, if there is no RTP activity within the timeout (in
seconds), the call will be terminated. The default setting is no timeout.
Note:
This setting doesn't apply to calls on hold.
When the call is on hold, if there is no RTP activity within the timeout (in
seconds), the call will be terminated. This value of RTP Hold Timeout
should be larger than RTP Timeout. The default setting is no timeout.
Configure whether the Remote-Party-ID should be trusted. The default
setting is "No".
Configure whether the Remote-Party-ID should be sent or not. The
default setting is "No".
Configure whether the UCM6100 should generate inband ringing or not.
The default setting is "Never".
Yes: The UCM6100 will send 180 Ringing followed by 183 Session
x
Progress and in-band audio.
No: The UCM6100 will send 180 Ringing if 183 Session Progress
x
has not been sent yet. If audio path is established already with 183
then send in-band ringing.
Never: Whenever ringing occurs, the UCM6100 will send 180
x
Ringing as long as 200OK has not been set yet. Inband ringing will
not be generated even the end point device is not working properly.
UCM6100 Series IP PBX User Manual Page 135 of 159