Sip Settings/Tcp And Tls; Table 51: Sip Settings/Tcp And Tls - Grandstream Networks UCM6108 User Manual

http://arttel.ru
Session Expire
Min SE
Session Refresher

SIP SETTINGS/TCP and TLS

TCP Enable
TCP Bind Address
TLS Enable
TLS Bind Address
TLS Client Protocol
TLS Do Not Verify
TLS Self-Signed CA
Firmware Version 1.0.2.21
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102
Refuse
x
Do not run session timer.
Configure the maximum session refresh interval (in seconds). The
default setting is 1800.
Configure the minimum session refresh interval (in seconds). The
default setting is 90.
Select the session refresher to be UAC or UAS. The default setting is
UAC.

Table 51: SIP Settings/TCP and TLS

Configure to allow incoming TCP connections with the UCM6100. The
default setting is "No".
Configure the IP address for TCP server to bind to. 0.0.0.0 means
binding to all interfaces. The port number is optional. If not specified,
5060 will be used.
Configure to allow incoming TLS connections with the UCM6100. The
default setting is "No".
Configure the IP address for TLS server to bind to. 0.0.0.0 means
binding to all interfaces. The port number is optional. If not specified,
5061 will be used.
Note:
The IP address must match the common name (hostname) in the
certificate. Please do not bind a TLS socket to multiple IP addresses.
For details on how to construct a certificate for SIP, please refer to the
following document:
http://tools.ietf.org/html/draft-ietf-sip-domain-certs
Select the TLS protocol for outbound client connections. The default
setting is TLSv1.
If enabled, the TLS server's certificate won't be verified when acting as a
client. The default setting is "Yes".
This is the CA certificate if the TLS server being connected to requires
self-signed certificate, including server's public key. This file will be
renames as "TLS.ca" automatically.
UCM6100 Series IP PBX User Manual Page 132 of 159