Grandstream Networks UCM6108 User Manual page 72

http://arttel.ru
Password
Auth ID
Codec Preference
From Domain
From User
Outbound Proxy Support
Outbound Proxy
Enable Qualify
Qualify Timeout
Qualify Frequency
Fax Detection
SRTP
Peer IAX Trunk Configuration Parameters
Provider Name
Firmware Version 1.0.2.21
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102
Enter the password to register to the trunk from the provider.
This is the authentication ID for the UCM6100 to register to the trunk if
required by the provider. If not specified, the CallerID name will be sued
for authentication.
Select audio and video codec for the VoIP trunk. The available codecs
are: PCMU, PCMA, GSM, AAL2-G.726-32, G.722, G.729, G.723, ILBC,
ADPCM, LPC10, H.264, H.263, H.263p.
Configure the actual domain name where the extension comes from.
This can be used to override the From Header.
For example, "trunk.UCM6100.provider.com" is the From Domain in
From Header: sip:1234567@trunk.UCM6100.provider.com.
Configure the actual user name of the extension. This can be used to
override the From Header. There are cases where there is a single ID
for registration (single trunk) with multiple DIDs.
For example, "1234567" is the From User in From Header:
sip:1234567@trunk.UCM6100.provider.com.
Select to enable outbound proxy in this trunk. The default setting is "No".
When outbound proxy support is enabled, enter the IP address or URL
of the outbound proxy.
If enabled, the UCM6100 will regularly send SIP OPTIONS to the device
to check if the device is still online. The default setting is "No".
When "Enable Qualify" option is set to "Yes", configure the timeout (in
ms) for the Qualify SIP message. If no response is received within the
timeout, the device is considered offline. The default setting is 1000ms.
When "Enable Qualify" option is set to "Yes", configure the interval (in
seconds) of the SIP OPTIONS message sent to the device to check if
the device is still online. The default setting is 60 seconds.
Enable to detect Fax signal from the trunk during the call and send the
received Fax to the default Email address in Fax setting page under web
GUI->PBX->Internal Options->Fax/T.38.
Note:
If enabled, Fax Pass-through cannot be used.
Enable SRTP for the VoIP trunk. The default setting is "No".
Configure the provider name for the VoIP trunk. This is a unique label to
UCM6100 Series IP PBX User Manual Page 71 of 159