Grandstream Networks UCM6108 User Manual page 120

http://arttel.ru
Call Park
Parked Lots
Parking Timeout (s)
Feature Codes
Voicemail Access Code
My Voicemail
Agent Pause
Agent Unpause
Paging Prefix
Intercom Prefix
Blacklist Add
Blacklist Remove
Call Pickup on Ringing
Firmware Version 1.0.2.21
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102
Configure the maximum interval (in milliseconds) between the
x
digits input to activate the feature code.
Default Extension: 700.
x
During an active call, initiate blind transfer and then enter this
x
code to park the call.
Default Extension: 701-720.
x
These are the extensions where the calls will be parked, i.e.,
x
parking lots that the parked calls can be retrieved.
Default setting: 300.
x
This is the timeout allowed for a call to be parked. After the
x
timeout, if the call is not picked up, the extension who parks
the call will be called back.
Default Code: *98.
x
Enter *98 and follow the voice prompt. Or dial *98 followed by
x
the extension and # to access the entered extension's
voicemail box.
Default Code: *97.
x
Press *97 to access the voicemail box.
x
Default Code: *83.
x
Pause the agent in all call queues.
x
Default Code: *84.
x
Unpause the agent in all call queues.
x
Default Code: *81.
x
To page an extension, enter the code followed by the
x
extension number.
Default Code: *80.
x
To intercom an extension, enter the code followed by the
x
extension number.
Default Code: *40.
x
To add a number to blacklist for inbound route, dial *40 and
x
follow the voice prompt to enter the number.
Default Code: *41.
x
To remove a number from current blacklist for inbound route,
x
dial *41 and follow the voice prompt to remove the number.
Default Code: **.
x
To pick up a call for any extension xxxx, enter the code
x
followed by the extension number xxxx.
UCM6100 Series IP PBX User Manual Page 119 of 159