Table Of Mewtocol-Com Communication Error - Panasonic FP0R User Manual

15.4.3 Table of MEWTOCOL-COM Communication Error

Error
Name
code
!21 NACK error
!22 WACK error
!23 Unit No. overlap
Transmission format
!24
error
Link unit hardware
!25
error
!26 Unit No. setting error
!27 No support error
!28 No response error
!29 Buffer closed error
!30 Time-out error
Transmission
!32
impossible error
!33 Communication stop
!36 No destination error
Other communication
!38
error
!40 BCC error
!41 Format error
!42 No support error
Multiple frames
!43
procedure error
!50 Link setting error
Transmission
!51
time-out error
Transmit disable
!52
error
!53 Busy error
!60 Parameter error
!61 Data error
Registration over
!62
error
!63 PC mode error
15-78
Link system error
Link system error
Link system error
Link system error
Link system error
Link system error
Link system error
Link system error
Link system error
Link system error
Link system error
Link system error
Link system error
Link system error
A transfer error occurred in the received data.
A command was received that does not fit the format.
A command was received that is not supported.
A different command was received when processing multiple
frames.
A route number that does not exist was specified. Verify the route
number by designating the transmission station.
Transmission to another device not possible because transmission
buffer is congested.
Transmission processing to another device is not possible.(Link
unit runaway, etc.)
Command process cannot be received because of multiple frame
processing. Or, cannot be received because command being
processed is congested.
Content of specified parameter does not exist or cannot be used.
There was a mistake in the contact, data area, data number
designation, size designation, range, or format designation.
Operation was does when number of registrations was exceeded
or when there was no registration.
PC command that cannot be processed was executed during RUN
mode.
Description