Table of Contents
Advertisement
10.7 Error Codes List
10.7.1 List of MEWTOCOL-COM Communication Error Codes
Code
!26
Unit number setting error
!40
BCC error
!41
Format error
!42
NOT support error
!43
Multiframe process error
!60
Parameter error
!61
Data error
!62
Registration over error
!63
PC mode error
!64
External memory error
!65
Protection error
!66
Address error
No program error
!67
/ no data error
Rewrite forbidden in RUN
!68
mode error
!70
SIM over error
!71
Exclusive control error
(Note 1)
Each error code is returned in hexadecimal data format
WUME-FPXHCOMG-02
Name
A command that cannot be used for global (unit no. FF) was
received.
Transmission error occurred in received data.
Command that does not match the format was received.
An unsupported command was received.
Another command was received during the multiframe processing.
Specified parameter does not exist, or cannot be used.
There is an error in the contact, data area, data number, size, range
or format specification.
The number of registration exceeded the restriction, or operation is
performed without registration.
Invalid command was executed in RUN mode.
Hardware failure. There could be an error in the built-in ROM
(FROM) / main memory.
The capacity of the specified content was exceeded during ROM
transmission.
A read / write error occurred.
A write operation of the program or system register was performed
under the protection status (password setting) or with the Master
Memory Cassette installed.
The code format of address data is incorrect. If the address is
exceeded or insufficient, the range specification is incorrect.
Program cannot be read as there is no program in program area or
an error in memory contents. Or, an attempt was made to read
unregistered data.
An attempt was made to edit instructions (ED, SUB, RET, INT, IRET,
SSTP, STPE) that cannot be rewritten in the RUN mode. Nothing is
written to the Control Unit.
Program area was exceeded during a program write process.
A command that cannot be processed simultaneously with the
command in process was executed.
10.7 Error Codes List
Error code contents
10-29
Advertisement
Table of Contents
