Panasonic FP0R User Manual page 276

WR904 FP0R
Relay
Name
No.
TOOL port
R9040 operation mode
flag
COM port PLC
R9041
link flag
R9042 Not used
R9043 Not used
COM port
SEND/RECV
R9044
instruction
execution flag
COM port
SEND/RECV
R9045 instruction
execution end
flag
R9046 Not used
R9047 Not used
R9048 Not used
R9049 Not used
R904A Not used
R904B Not used
R904C
Not used
to R904F
A: Available, N/A: Not available
Note) R9040 to R904F can be changed during 1 scan.
WR905 FP0R
Relay
Name
No.
MEWNET-W0
PLC link
R9050
transmission
error flag
R9051 to
Not used
R905F
15-14
Turns on when the general-purpose communication function is being
-
used
Goes off when the computer link function is being used.
-
Turn on while the PLC link function is used.
Monitors whether the F145 (SEND) or F146 (RECV) instructions can
be executed or not.
Off: None of the above mentioned instructions can be executed.
(During executing the instruction)
On: One of the above mentioned instructions can be executed.
Monitors if an abnormality has been detected during the execution of
the F145 (SEND) or F146 (RECV) instructions as follows:
Off: No abonormality detected.
On: An abnormality detected. (communication error)
End code: DT90124
When using MEWNET-W0
Turns on when a transmission error occurs at PLC link.
-
Turns on when there is an error in the PLC link area settings.
-
Description
Description