Panasonic FP0R User Manual page 339

Error
Name
code
MEWNET-F
terminal
E51
station
error
MEWNET-F
I/O update
E52
synchro-
nous error
Multi-CPU
I/O regis-
tration
E53
error
(CPU2
only)
IC memory
card back-
E54
up battery
error
IC memory
card back-
E55
up battery
error
Incompati-
ble IC
E56
memory
card error
No unit for
the
E57
configu-
ration
E100 Self-
to diagnostic
E199 error set
by F148
E200
(ERR)/P148
to
(PERR)
E299
instruction
Opera-
tion Description and steps to take
status
Terminal station setting was not properly
performed.
Conti-
Check stations at both ends of the
nues
communication path, and set them in the
terminal station using the dip switches.
Set the INITIALIZE/TEST
selecto1inmjvbgycfrde892 r to the
Conti-
INITIALIZE position while keeping the mode
selector in the RUN position. If the same
nues
error occurs after this, please contact your
dealer.
Abnormality was detected when the multi-
Conti-
CPU system was used.
nues
Please contact your dealer.
The voltage of the backup battery for the IC
memory card lowered. The BATT.LED does
Conti-
not turn on.
Charge or replace the backup battery of IC
nues
memory card.(The contents of the IC
memory card cannot be guaranteed.)
The voltage of the backup battery for IC
memory card lowers. The BATT.LED does
not turn on.
Cont-
Charge or replace the backup battery of IC
inues
memory card.
(The contents of the IC memory card cannot
be guaranteed.)
The IC memory card installed is not
Cont-
compatible.
Replace the IC memory card compatible
inues
with FP2SH/FP10SH.
MEWNET-W2/MCU
The MEWNET-W2 link unit or
MCU(Multi communication unit) is not
Conti-
installed in the slot specified using the
nues
configuration data.
Either install a unit in the specified slot or
change the parameter.
The error specified by the F148
(ERR)/P148(PERR) instruction is occurred.
Stop
⇒ Take steps to clear the error condition
according to the specification you chose.
Conti-
nues
A
A
A
A A A A A A
A A A A A A
A :Available
A A
A A
A
A A
A A
A A
A
15-77