4.2 Interfaces Of The Sinumerik 810D; Brief Description - Siemens SINUMERIK 810D Configuration Manual

4 Description of the SINUMERIK 810D

4.2 Interfaces of the SINUMERIK 810D

4.2 Interfaces of the SINUMERIK 810D
4.2.1

Brief description

CCU1/CCU2
The CCU/CCU2 modules have the following interfaces:
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
CCU3
The CCU3 module has an additional pulse interface.
4-54
Optical encoders (max. six measuring systems for raw voltage signal
encoders,
1V , incremental/absolute with the EnDat interface )
PP
Three axis expansion terminals for up to three ext. power sections
Drive bus for axis expansion with 611D modules and connection of NCU
terminal block
PCMCIA slot
On--board backup battery
Connection for cable distributor (handwheel, probe)
MPI interface for operator panel front, programming device, etc.
PLC I/O bus (P/C bus)
Option: PROFIBUS DP on CCU2 from SW 3
Ext. pulse enable jointly for all drives
Starting lockout, terminals AS1, AS2
BERO input for ext. zero marker (spindle)
Displays for error, status and booting
Operator control elements for start--up, delete, reset
Four test sockets for diagnostics
Device bus interface.
SINUMERIK 810D Manual Hardware Configuration (PHC) - - 11.02 Edition
E Siemens AG, 2002. All rights reserved
11.02
12.95