Siemens SINUMERIK 810D Configuration Manual page 54

4 Description of the SINUMERIK 810D
4.1 Components of the SINUMERIK 810D
PCMCIA card
SW 3 and higher:
(NC card) The NC card with the system software must remain inserted during
operation.
Note
When upgrading the software, the export software can be copied onto the
internal flash EPROM.
SW 6.3 and higher:
Also valid for CCU3 standard software.
In addition to software upgrading, the PCMCIA card can also be used as a
memory for series machine startup; see
References: /IAC/ Installation Guide 810D.
6th axis
SW 3.2 and higher, a 6th axis can be operated on CCU1; see Section 4.8.
(SW 3.2 and higher)
CCU3 module
Differences to CCU1/2:
S
S
S
S
Closed-loop
Closed--loop control corresponds to 611D standard closed-loop control, with the
control
following restrictions:
Main restrictions
The following are not available:
for NCU 840D
S
S
S
S
S
S
4-52
Software compatible with NCU SW 6.
Up to six axes and two channels can be operated simultaneously.
2Two MSDs are supported.
The complete motor range can be used (1FE, 1FN, 1FW ...).
5-axis transformation
Safety Integrated
Analog axis
Hydraulic drives
Independent drive stop/retract
3D clearance control.
SINUMERIK 810D Manual Hardware Configuration (PHC) - - 11.02 Edition
E Siemens AG, 2002. All rights reserved
11.02
12.95