Interfaces; Simotion C Interfaces; Ethernet Interface - Siemens SIMOTION C 230-2 Operating Instructions Manual

Interfaces

4.1

SIMOTION C interfaces

The interfaces and their meaning are described in following table.
Table 4-1
Interfaces
Bus connector
Drive interface (onboard)
(C230-2, C240)
Measuring system interface
(onboard) (C230-2, C240)
I/O interface
Power supply connection
Memory module slot
PROFIBUS DP1 interface
PROFIBUS DP2/MPI interface

Ethernet interface

PROFINET interface with three
ports (C240 PN)
4.2 Ethernet interface
Definition
Interface for connecting an Industrial Ethernet.
Industrial Ethernet is a communication network with a transmission rate of 10/100 Mbit/s.
SIMOTION C
Operating Instructions, 11/2022, A5E33441428B
Interfaces
Description
Rear-mounted connector for connecting to other S7 modules via the I/O
bus
50-pin Sub-D connector X2 for the analog connection of analog and
stepper drives (max. 4 axes)
15-pin Sub-D sockets X3 to X6 for connection of encoders (max. 4)
40-pin front connectors X1 for connecting the fast digital inputs/digital
outputs including measuring inputs and external zero mark and for wir‐
ing the READY relay
4-pin screw-type terminal connection X10 for connecting the 24 V load
power supply
Slot for micro memory card (MMC)
9-pin Sub-D socket X8 for connection to the PROFIBUS DP. This interface
can be used for isochronous operation
9-pin Sub-D socket X9 for connection to PROFIBUS DP (factory setting)
or an MPI bus
This interface can be used for isochronous operation.
8-pin RJ45 socket X7 for connection to an Industrial Ethernet
3 x 8-pin RJ45 sockets X11 P1, X11 P2 and X11 P3 for connecting to
PROFINET subnets
4
43