Siemens SINUMERIK 810D Configuration Manual page 108

8 DMP Compact Modules
8.2 DMP compact module 16O (6FC5 111-0CA02-0AA1)
Table 8-2
Output loading at "1" signal (rated value)
Short-circuit protection
Power loss at 30V
Switching rate at
Total load capacity at 55_C (as referred to the sum of the
rated currents of all outputs)
Delay time
Delay time
Cable length
Weight
Degree of protection according to DIN 40050
Humidity rating according to DIN 40040
Important
!
A new output driver is used for the DMP compact module 16A as from product
version C. Observe the following behavior:
In the event of malfunction, caused by overcurrent or short circuit, the outputs
will automatically switch through again after the fault has been removed (pre-
viously: latching switchoff until output is reselected by the PLC user program).
In the case of a short-circuit of one output, the three other outputs of the same
half byte can likewise switch off.
There will be no interaction in normal operation with currents < 0.7A.
Eight outputs each are fed from one power supply. The sum of the output
currents must not exceed 2A for eight outputs (2x outputs 0 ... 7) (this
corresponds to a simultaneity factor of 50% at full load of the individual outputs).
All 16 outputs may be loaded simultaneously, e.g. with 0.25A.
Important
!
Switching surges must be neutralized by external free-wheeling diodes when
using inductive loads.
8-106
Technical data DMP compact module 16O
- Resistive load
- Lamp load
- Inductive load
- Resistive load
- Lamps
- Inductive load (at rated
load, higher values per-
missible at lower load)
for tp
LH
for tp
HL
SINUMERIK 810D Manual Hardware Configuration (PHC) - - 11.02 Edition
500mA
5W
500mA
Yes
Max. 3.8W
100Hz
11Hz
2Hz
50%
tp = max. 0.5msecs
LH
tp = max. 0.5msecs
HL
max. 50m
approx. 160g
IP20
F
E Siemens AG, 2002. All rights reserved
12.95