Print Function Test; Factory Maintenance; Accessing Factory Maintenance Menu; Drawing Waves - Mindray T1 Service Manual

5.4.7 Print Function Test

1 Enter the Demo mode of the patient monitor.
2 Select [Main Menu]→ [Print Setup >>]→ [Realtime Reports >>]→ [Normal Report] and then select [Print]. The
network printer should print out the report correctly.

5.5 Factory Maintenance

5.5.1 Accessing Factory Maintenance Menu

To access the factory maintenance menu, select [Main Menu]→ [Maintenance >>] → [Factory Maintenance>>] and then
enter the required password.

5.5.2 Drawing Waves

In the [Factory Maintenance>>] menu, select [Draw Wave] to define the method to draw waves. There are two methods to
draw waves:

Color: selecting Color will have smoother waveforms.

Mono: selecting Mono will have a wider viewing angle.

5.5.3 Checking Software Version

In the [Factory Maintenance] menu, select [Software Version] to show software version information.

5.5.4 Checking Monitor Information

In the [Factory Maintenance] menu, select [Monitor Information] to show the status of the patient monitor.
T1 Service Manual 5-13