Parameterize The Teleservice Adapter Ie With The "Teleservice" Software; Overview Of Teleservice Adapter Parameter Assignment - Siemens SINUMERIK 840D sl Operating Manual

Connection to the control
5.5 Establishing a modem connection
9. Under "Location > Name:" select the location of your PG/PC.
Click "Edit" if needed to open up the "Phone and
Modem Options" dialog box to set up a new location.
For more information on the location, refer to the help function for the "Edit location" dialog
box.
10.Click
"OK" to exit the "Properties - TS Adapter IE" dialog box.
If you have changed an access path in these settings, a
warning message then appears.
To accept the changes, click
"OK".
See also
Parameterize the TeleService adapter IE with the "TeleService" software (Page 38)
Assigning parameters for the TS Adapter (Page 43)
Parameterize the TeleService adapter IE without the "TeleService" software (Page 59)
5.5.3

Parameterize the TeleService adapter IE with the "TeleService" software

5.5.3.1

Overview of TeleService Adapter parameter assignment

Introduction
Parameters are assigned for the TeleService Adapter IE from the PC via the network.
Requirements
You must have connected the PC and the TeleService Adapter IE with an Ethernet cable via
the network (see figure below).
Network connection of the PC to the TeleService Adapter IE
38
SINUMERIK Integrate Access MyMachine /P2P (PC)
Operating Manual, 11/2016, A5E39356962B AA