Lubrication Points; Battery; Fuses - Arctic Cat DVX 400 2004 Service Manual

Lubrication Points

It is advisable to lubricate certain components periodi-
cally to ensure free movement. Apply light oil to the
components using the following list as reference.
A. Throttle Lever Pivot/Cable Ends
B. Brake Lever Pivot
C. Parking Brake Cable Ends
D. Choke Cable Upper End
E. Reverse Selector Cable End
F. Idle RPM Screw (Carburetor)
G. Rear Brake Pedal Pivot

Battery

The battery is located under the seat.
The battery in this ATV is a "sealed" type and does not
require any maintenance unless discharged. Distilled
water and/or electrolyte cannot be added to the battery.
! WARNING
Anytime service is performed on a battery, the fol-
lowing must be observed: Keep sparks, open flame,
cigarettes, or any other flame away. Always wear
safety glasses. Protect skin and clothing when han-
dling batteries. When servicing battery in enclosed
space, keep the area well-ventilated.
This maintenance-free battery requires periodic charging
to prevent sulfiding. If the ATV will be idle for extended
periods of time, either run the engine or trickle charge
from time to time. If the battery completely discharges,
permanent damage will occur requiring replacement.
If the battery is discharged, remove the battery from the
ATV and charge the battery at the standard charging rate
of 0.9 amps for 5-10 hours.
To remove and charge the battery, use the following pro-
cedure.
1. Remove the seat; then remove the battery hold-down
bracket.
2. Remove the negative battery cable; then remove the
positive cable and the battery vent tube. Remove the
battery from the ATV. Care should be taken not to
damage the vent tube.
Avoid spillage and contact with skin, eyes, and cloth-
ing.
Do not charge the battery while it is in the ATV
with the battery terminals connected.
3. Trickle charge the battery at 0.9 amps for 5-10 hours.
Never exceed the standard charging rate.
Before installing the battery, make sure the
ignition switch is in the OFF position.
4. Place the battery into position in the ATV and secure
with the hold-down bracket.
5. Connect cables to the proper terminals: positive
cable to the positive terminal (+) and negative cable
to the negative terminal (-). Connect the negative
cable last.
SP034
Connecting cables in reverse (positive to negative
and negative to positive) can cause serious
damage to the electrical system.
6. Install the seat making sure it locks securely.
There is one 20 amp fuse and one spare 20 amp fuse
located adjacent to the battery on the starter relay.
! WARNING
! CAUTION
! CAUTION
! CAUTION
! CAUTION

Fuses

SP034
3