Arctic Cat DVX 400 2004 Service Manual page 117

NOTE: Removed bushings must be replaced with
new ones.
5. To inspect front and rear arm bearings, insert the
spacer into the bearing; then check for excessive play
by moving the bearing up and down. If excessive
play is noted, the bearing must be replaced.
6. Remove the dust seals; then using a suitable bearing
puller and slide hammer, remove the defective bear-
ing.
NOTE: Removed bearings must be replaced with
new ones.
8
SP350
7. Remove the front arm bearings using a suitable bear-
ing puller set.
SP351
NOTE: Removed bearings must be replaced with
new ones.
8. To check pivot shaft runout, use a dial indicator. If
runout exceeds 0.3 mm (0.01 in.), replace the pivot
SP352
shaft.
SP353
SP354
SP355