Arctic Cat DVX 400 2004 Service Manual page 122

NOTE: The pivots are equipped with roller bear-
ings. The bearing rollers may fall out when the
spacers are removed.
5. Check the bearings for excessive wear and replace
them if worn.
6. Using a suitable bearing remover, remove the pivot
bearings; then clean all parts in parts-cleaning sol-
vent.
NOTE: All bearings, spacers, and seals that are
removed must be replaced with new ones.
INSTALLING
1. Using a bearing installer, install the ball joint in the
arm; then install the circlip.
SP380
2. Install the bearings in the upper arm pivot to a depth
of 12 mm (0.47 in.) with a bearing installer and suit-
able spacer. The stamped side of the bearing should
be directed toward the spacer (1).
SP381
SP382
SP383
SP384
SP385
ATV2196
13