Arctic Cat DVX 400 2004 Service Manual page 123

3. Coat the spacers (2) and the lips of the dust seals (3)
with multipurpose grease; then install them in the
upper pivot.
4. Install the bearing spacer (4), dust seals (5), dust cov-
ers (6), and washers (7) into the lower arm.
NOTE: The stamped mark on the dust seals must
be directed to the outside.
5. Clean all grease from the ball joint tapers and the
knuckle bores; then install the arms to the steering
knuckle and tighten the ball joint nuts to specifica-
tions. Install new cotter pins.
NOTE: During assembly, new cotter pins should
be installed.
14
6. Install the arms to the frame with the pivot cap
screws; then tighten the nuts to specifications.
SP386
7. Install the front bumper assembly; then install the
front shock absorbers. Use red Loctite #271 on the
cap screw threads and tighten to specifications.
SP387
8. Apply red Loctite #271 to the mounting cap screws;
then install the disc cover and tighten securely.
SP388A
SP390
SP391
SP392