Arctic Cat DVX 400 2004 Service Manual page 108

4. Apply Three Bond Sealant (p/n 0636-070) to the left
and right ends of the sprocket hub; then install the
hub on the axle.
NOTE: If the sprocket was removed, see Section
2 for sprocket installation procedure.
5. On the left-side, install the concave washers (3); then
apply red Loctite #271 to the threads on the axle and
using the torque wrench adapter, tighten the inner
axle nut to the calculated specification.
NOTE: It is necessary to calculate the torque
value using the following formula due to the offset
of the special tool used to tighten the axle nuts.
SP321
T: Torque wrench reading to be calculated
Ts: Specified torque value (130 ft-lb)
Ls: Tool offset length (center to center)
L: Length of torque wrench (handle pivot to head
center)
SP322
6. Install the outer axle nut (5) and tighten to calculated
specification.
7. Adjust the drive chain (see Section 2); then tighten
ATV2188
the four cap screws.
8. Install the brake caliper and tighten the mounting cap
screws to specifications; then install the wheel hubs
and tighten the rear wheel hub nuts to specifications.
9. Install the rear wheels and tighten to specifications.
L x Ts
= T
L + Ls
SP323
ATV2189
SP324
5