Fan Motor; Fuse Holder; Fuse - Arctic Cat DVX 400 2004 Service Manual

6. On the cooling fan switch, allow the water to cool,
and when the temperature is at (or just before) a tem-
perature of 82° C (180° F), the meter should read an
open circuit.
7. If the readings are not as indicated, the switch must
be replaced.
8. Install the switch and tighten securely.
9. Connect the switch leads.

Fan Motor

NOTE: The ignition switch must be in the ON
position.
VOLTAGE (Main Harness Connector
to Fan Motor)
1. Set the meter selector to the D.C. Voltage position.
2. Connect the red tester lead to the orange wire (the
black 2-prong at the fan motor); then connect the
black tester lead to ground.
3. The meter must show battery voltage.
NOTE: If the meter shows no battery voltage,
troubleshoot the battery, fuse, motor, or the main
wiring harness.
NOTE: If the meter shows battery voltage, the
main wiring harness is good. The connector
should be tested for resistance.
NOTE: To determine if the fan motor is good,
connect the red wire from the fan connector to a 12
volt D.C. power supply; then connect the black/red
wire from the fan connector to ground. The fan
should operate.
! CAUTION
Care should be taken to keep clear of the fan
blades.

Fuse Holder

The fuse and a spare are located on the starter relay under
the seat.
4
1. Remove the fuse from the starter relay.
2. Set the meter selector to the D.C. Voltage position.
3. Connect the black tester lead to ground.
4. Using the red tester lead, contact the battery side of
the fuse holder connector terminal.
5. The meter must show battery voltage.
NOTE: Battery voltage will be indicated from only
one side of the fuse holder connector terminal; the
other side will show an open circuit.
NOTE: If the meter shows no battery voltage,
troubleshoot the battery, switches, fuse holder, or
the main wiring harness.

Fuse

! CAUTION
Always disconnect the battery when performing
resistance tests to avoid damaging the multimeter.
1. Set the meter selector to the OHMS position.
2. Connect the red tester lead to one spade end of the
fuse; then connect the black tester lead to the other
spade end.
3. The meter must show less than 1 ohm resistance. If
the meter reads open, replace the fuse.
SP032A
AR610D