Periodic Maintenance; Lubrication Points; Air Filter - Arctic Cat 2015 XR Service Manual

Periodic Maintenance

This section has been organized into sub-sections which show
common maintenance procedures for the Arctic Cat ATV.
 NOTE: Arctic Cat recommends the use of new gas-
kets, lock nuts, and seals and lubricating all internal
components when servicing the engine/transmission.
SPECIAL TOOLS
A number of special tools must be available to the techni-
cian when performing service procedures in this section.
Description
Compression Tester Kit
Oil Filter Wrench
Spanner Wrench
Valve Clearance Adjuster
 NOTE: Special tools are available from the Arctic
Cat Service Department.

Lubrication Points

It is advisable to lubricate certain components periodi-
cally to ensure free movement. Apply light oil to the
components using the following list as reference.
A. Throttle Lever Pivot
B. Brake Lever Pivot
C. Auxiliary Brake Pedal Pivot

Air Filter

1. Remove the seat; then remove the clips securing the
air filter housing cover.
2. Loosen the clamp securing the air filter to the inside
of the housing; then remove the filter.
6
3. Carefully remove the pre-filter from the air filter. If
the air filter is dirty, it must be replaced.
p/n
0444-213
0644-389
0444-240
0444-255
4. Using an air hose, clean the pre-filter.
5. Slide the pre-filter over the closed end of the new fil-
ter and install into the housing. Tighten the clamp
securely.
6. Install the air filter housing cover and secure with the
clips.
7. Install the seat.
CHECKING AND CLEANING DRAINS
1. Inspect the drains beneath the main housing for
water/oil and for proper sealing.
XR002A
XR029A
XR049
XR055A