Table 5.63
Display PHY Connection Information
Convention
MegaCli –PHYInfo -phyM –aN|-a0,1,2|-aALL
Description
Displays PHY connection information for physical PHY M on the controller(s).
5.15 Diagnostic-Related Options
5.15.1
Start Controller Diagnostics
Table 5.64
Start Diagnostics Setting
Convention
MegaCli –AdpDiag [val] –aN|-a0,1,2|-aALL
Description
Sets the amount of time for the controller diagnostic to run.
5.15.2
Start Battery Test
Table 5.65
Start Battery Test
Convention
MegaCli –AdpBatTest –aN|-a0,1,2|-aALL
Description
Starts the battery test. This command requires that you turn off the power to the
system, and then turn on the power and reboot the system.
5.15.3
Start NVRAM Diagnostic
A port can contain a single PHY or can contain multiple PHYs. A narrow
port contains a single PHY, and a wide port contains multiple PHYs.
The commands in this section are used to run diagnostic tests.
Use the command in
amount of time.
Use the command in
requires a system reboot.
Use the command in
for a set amount of time. This option is for DOS only.
Diagnostic-Related Options
Table 5.64
to start the controller diagnostic for a set
Table 5.65
to start the battery test. This command
Table 5.66
to start the controller NVRAM diagnostic
5-37